|
Place rotating crescent against tubing.
Apply forward pressure until the punch pin pierces the tubing. If larger
holes are desired, remove pullet punch cutter from the storage holder on
top of the blade handle.
|
Insert emitter or barb in either rear or
bottom barb holder. Place emitter barbed point against punched hole in
tubing. Apply pressure until the emitter barb pierces tubing. Does not
work with all 1/4" barbs or emitters.
. |
Install emitter with 1/4" tubing attached
into crescent slots on bottom of punch handle. Place shoulder of emitter
on outside edge of handle with 1/4" tubing pressed into crescents, place
emitter barb against punched hole in tubing. Apply pressure until emitter
pierces tubing. |
Place eased edge on bottom of punch handle
against emitter at 45° angle. Apply pressure until emitter edge is lifted
and seated into crescents. While holding emitter assembly in crescents
rotae tool backward until emitter is removed.
|
Lightly squeeze handles together while roatating them
up and down. As tubin cut, reduce pressure and the end of cut.
|
